# "TUNE" settings

**URL:** <https://forum.lulzbot.com/t/tune-settings/6664>\
**Category:** Software\
**Created:** [April 20, 2019, 10:48pm UTC](https://forum.lulzbot.com/t/tune-settings/6664 "2019-04-20T22:48:12Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Imgona](https://avatars.discourse-cdn.com/v4/letter/i/edb3f5/32.png) [@Imgona](https://forum.lulzbot.com/u/Imgona)\
**Post date:** [April 20, 2019, 10:48pm UTC](https://forum.lulzbot.com/t/tune-settings/6664/1 "2019-04-20T22:48:12Z")

</div>

Trying to use the “tune” settings during a print. Is the “probe Z offset” the same as “baby Z steps” ? Tried using the “probe Z offset” turned the dial could see the graphics jump up or down but the numbers did not change. Thank you

---

<div class="post-metadata">

**Author:** ![Orias](https://sea2.discourse-cdn.com/flex020/user_avatar/forum.lulzbot.com/orias/32/3_2.png) [@Orias](https://forum.lulzbot.com/u/Orias)\
**Post date:** [April 26, 2019, 8:18pm UTC](https://forum.lulzbot.com/t/tune-settings/6664/2 "2019-04-26T20:18:50Z")

</div>

Reach out to the support team for help tuning your prints: [https://LulzBot.com/Support](https://LulzBot.com/Support). In the meantime, you can adjust the Z-axis offset on the fly during a print, adjust it during the first layer ideally and the rest of your print should come out just right.