v3 duel extruder issue

I just added the modular heat bed and now the E2 nozzle is dragging into my print on a right to left moment. Its not enough of an impact to make the print fail but you can see the effects in an otherwise perfect print.

I have made sure the new heat bed is seated correctly and the auto level corner sensors are fully seated…



Since it is only dragging during specific movements it would probably be a good idea to verify that your X-axis is sitting level to the frame. Try following this guide and see if one side of your X-axis is very slightly lower than the other: https://ohai.lulzbot.com/workflow/leveling-x-axis/maintenance-repairs/