Workhorse Stringing/Under Extrusion Issues

[ducksauce88]

I had major stringing issues in the beginning with my Workhorse. When I raised the heat the stringing would go away but then id have some oozing. For me, I will use a copper plated nozzle on the workhorse…always. I did purchase some brass nozzles but I have yet to try them on my machine.

Horrible hairy stringing on TAZ Workhorse

I received my TAZ workhorse earlier this week. I had horrible hairy prints with the polymaker pla, but I was able to drill down that it was due to the heat. I had to set it to 230C to resolve the issue, however there is still minimal stringing with the polymaker filament, but its acceptable. I’m using esun filament now, and I’m seeing the same sort of hairy/stringing with all different sorts of heating and retraction settings. I have not done any sort of calibrating, should I look into that? I…