Thanks for the helpWeekend_warrior1999 wrote:Define probe as z end stop
Remove x0 y0 reference in g28 command just use "g28"
Ensure eeprom settings and chitchat are enabled
This should activate probe during g28 command
G29 command activates probe for bed leveling
Eeprom settings and chitchat enable the printer to recall the probe measurements for tram correction.
Also how I setup the "z" offset is to temporarily disable min_software_endstop for z. Then set z extruder offset to "0". I then upload the firmware and run g28. I then manually (via the smart controller) lower the z till the nozzle is at the desired height. Then read the DRO for Z on the LCD, it should be a negative number, this will be your new "z" offset. Change it, re-upload, test. Once happy, re-enable min software endstops.
The thing is that I have already tried all these things.
I have tried all the possible combinations between G28 and G29 commands and all the axes.
I have set up the probe clearances exactly the same way you described.
I have set up the servo (motor and pins) just fine.
But, for the love of all gods and goddesses on earth, it simply doesn't want to work with me. If not for the process I described before, the board will completely ignore the probe results (which btw are there, I can see them on the LCD, on Pronterface, everywhere!!) and starts printing up in the air, as if the probe never happened....
So, I have to admit that I've been beat and lately I'm trying to develop a 0.1mm touch switch in conjunction with the servo, that will allow me to probe not just the four corners but other points as well.