Page 6 of 6

Re: First dual extrusion print from a Cyclops hot end and BondTech QR extruders

Posted: Sat May 21, 2016 8:46 pm
by luke1
I was wanting to know if @mhackney could post your Kissslicer settings? Thanks again

Re: First dual extrusion print from a Cyclops hot end and BondTech QR extruders

Posted: Tue Nov 01, 2016 9:10 pm
by theBLOCK
mhackney wrote:Happy to. They aren't complete since I haven't added a part cooling fan capability yet. But here's what I have so far...
TAZ_Cyclops_Mount.stl
I was wondering if there was any updates to this mount over the last year?

I'm just about a year late finding out about the Cyclops hotend with QR extruder setup for my Taz 5 setup. I was hoping to get an update on the complete setup for conversion. So anyone can hit the ground running.

Hot End
https://www.filastruder.com/products/chimera-cyclops

Extruder
http://shop.bondtech.se/ec/extruders/

Is anyone using this in Repetier & Slic3r

Re: First dual extrusion print from a Cyclops hot end and BondTech QR extruders

Posted: Thu Nov 10, 2016 6:10 pm
by mhackney
Not really, it's been working fine so I haven't had a need to tweak it. Not sure if/why you would need an update. Let me know.

cheers,
Michael