Page 1 of 1

Chimera/Cyclops Titan Mount

Posted: Sun Feb 12, 2017 12:46 pm
by nbmoretto
I have been working for a while on a direct drive mount for the Chimera/Cyclops using titan extruders. Due to the size of the Titans the best I could do was to do an elongated direct drive. The stepper motors I used are great because you can plug them directly into the existing cables. I am not 100% sure if they are compatible so if someone could double check for me that would be great! They can be found here: http://www.omc-stepperonline.com/nema-1 ... p-260.html

In addition, I am using the BLTouch probe. I am also hoping to find a good method to mount cooling fans if anyone has some input. I am currently printing out a stiffened mount as well.
16732049_1587750287908881_1910838286_o.jpg
16709285_1587750247908885_547993679_o.jpg
16706835_1586530341364209_542729529_n.png
16700082_1586530498030860_1244433944_n.png
16683096_1586531654697411_643324331_n.png

Re: Chimera/Cyclops Titan Mount

Posted: Sat Feb 18, 2017 7:14 pm
by nbmoretto
Updated V2
-Stiffened mount
-Decreased distance from extruder to hotend
-Cooling duct
16804862_1594682867215623_1656433396_o.jpg
16804917_1594671047216805_1346496815_o.jpg
16805321_1594671063883470_1548918105_o.jpg

Re: Chimera/Cyclops Titan Mount

Posted: Sat Feb 18, 2017 7:23 pm
by mhackney
Nice work!

Re: Chimera/Cyclops Titan Mount

Posted: Mon Jul 23, 2018 2:18 am
by forester
It looks great, thank you for sharing!!!

Re: Chimera/Cyclops Titan Mount

Posted: Thu Jul 18, 2019 3:19 pm
by fluffywhitebunny
I know this is a year old topic, but did you get everything up and working? Any plans on posting your designs? Thanks!