Taz 6 LED set up

Want to use the Open Source Hardware documentation to make your LulzBot 3D Printer do even more? Start here!
Post Reply
Posts: 31
Joined: Sun Feb 19, 2017 8:01 pm

Taz 6 LED set up

Post by InfiniteGinger » Sun Mar 26, 2017 5:53 pm

Ok i've read everything in there is to read about adding LED's to Taz. At least I think I have. I'd like to add multi color LED to my printer and have it controlled by OctoPrint. Found two plugins, has anyone done this? Do you have a guide or something with more info? I can do this, I just need better instructions. My knowledge of Arduino is limited. I found 2 plugins,

Love this one!

This one is would work too:


Just would like to find some sort of wiring diagram and a guide with instructions on how to integrate Raspi and Arduino...

User avatar
Posts: 4028
Joined: Sun Aug 25, 2013 1:37 am
Location: Battleground, WA

Re: Taz 6 LED set up

Post by piercet » Sun Mar 26, 2017 6:05 pm

Well, this one is controlled off the Rambo board itslef, not the PI, but you could use the case
http://www.thingiverse.com/thing:2203592 There is a link to the build thread with instructions and the sample firmware, which will NOT work with na stock 6, you'll have to code your own.

If you want the overhead gantry lighting too, I reccommend this one:

Posts: 156
Joined: Tue Jan 20, 2015 4:04 pm

Re: Taz 6 LED set up

Post by vitormhenrique » Wed Apr 12, 2017 1:04 pm

I guess i can add neopixel / dotstart to my plugin...

Post Reply