Hi guys.
I would like to change the extruder of my TAZ 5. I already upgraded it to a TAZ 6. Is it possible to change the extruder of a TAZ 5 printer with a E3D Titan?
thx
Hi guys.
I would like to change the extruder of my TAZ 5. I already upgraded it to a TAZ 6. Is it possible to change the extruder of a TAZ 5 printer with a E3D Titan?
thx
Never mind, I read e3dv6. Here is a titan design https://www.thingiverse.com/thing:2147519
Ignore the rest of this
Yes, there are several designs that will accommodate that, such as
https://www.thingiverse.com/thing:1538341 or
https://www.thingiverse.com/thing:2169219
Those are both my designs, there are several others as well. The first link is the closest to a traditional taz 6 design. The second link is a much more radical design. You will need to run your leveling wire to a screw on the heater block somewhere in either case to complete the taz 6 leveling circuit.
How to flash the new extruder on the TAZ 5? Is there a video on youtube as to how connect the wires to the harness of the TAZ? I didn’t find any.