a lot of Lulzbot hardware

Want to use the Open Source Hardware documentation to make your LulzBot 3D Printer do even more? Start here!
Post Reply
vincitytaymodaimo
Posts: 2
Joined: Thu Oct 11, 2018 1:24 am

a lot of Lulzbot hardware

Post by vincitytaymodaimo » Sun Oct 21, 2018 7:29 pm

I'm working on designing my own rig with a lot of Lulzbot hardware (I'd buy one, but I'm a poor Industrial Design student). I built a Prusa i2 from Northwest RepRap this summer and it was an interesting learning experience, but the design is sorely lacking in more than a few ways, so I'm working on my own.

Post Reply