Latest Firmware for TAZ5 - advanced development version

Look here for custom firmware, networked 3D printer hosts like OctoPrint, and more!
Rp1030
Posts: 82
Joined: Tue Apr 28, 2015 9:20 am

Re: Latest Firmware for TAZ5 - advanced development version

Post by Rp1030 » Thu May 30, 2019 10:23 pm

Aliasmeum

I am trying to adapt version 1.1.9 to work with my taz 5 and it is, mostly..

The lcd menu seems slower and when I move my axis manually in any direction, there is a very distinct lag between moves. I think I’m doing something wrong. I just don’t know what 😖

aliasmeum
Posts: 17
Joined: Sun Feb 21, 2016 4:14 am

Re: Latest Firmware for TAZ5 - advanced development version

Post by aliasmeum » Sat Jun 01, 2019 3:28 am

If you look in Configuration.h you can find the following lines:
#define ENCODER_PULSES_PER_STEP 4
and
#define ENCODER_STEPS_PER_MENU_ITEM 1
try changing these values to get the desired behaviour off the LCD.
(If I remember right, Lulzbot is using 2 for the pulses and 1 for the steps)

Best regards
Robert

Rp1030
Posts: 82
Joined: Tue Apr 28, 2015 9:20 am

Re: Latest Firmware for TAZ5 - advanced development version

Post by Rp1030 » Sun Jun 02, 2019 9:52 am

This setting is helpful, yet does not solve my issue.

I can turn any axis to any number ex. 50mm and it will only move like 2 mm +/-
I cant figure this setting out.




aliasmeum wrote:
Sat Jun 01, 2019 3:28 am
If you look in Configuration.h you can find the following lines:
#define ENCODER_PULSES_PER_STEP 4
and
#define ENCODER_STEPS_PER_MENU_ITEM 1
try changing these values to get the desired behaviour off the LCD.
(If I remember right, Lulzbot is using 2 for the pulses and 1 for the steps)

Best regards
Robert

Post Reply