Cura Lulzbot 2.6.46 and Ultimaker 3.04

Look here for custom firmware, networked 3D printer hosts like OctoPrint, and more!
Post Reply
sierradays
Posts: 5
Joined: Sun Dec 11, 2016 11:51 am

Cura Lulzbot 2.6.46 and Ultimaker 3.04

Post by sierradays » Tue Nov 07, 2017 6:20 pm

Iam having an issue with the Lulzbot and Ultimaker Cura only allowing one of the versions to run at a time. Iam trying to run both the Luzbot and Ultimaker Version of Cura at the same time because I have both a Taz 6 and a UM3. Is anyone else having this issue?

sierradays
Posts: 5
Joined: Sun Dec 11, 2016 11:51 am

Re: Cura Lulzbot 2.6.46 and Ultimaker Cura 3.04 Update

Post by sierradays » Wed Nov 08, 2017 8:41 am

Update

UM3 Cura loads splash screen but does not complete/Run. I can get the Lulzbot/Cura version to run.

These versions are not getting along on the same computer, which is running Win7.

Post Reply