Page 1 of 1

Cura LulzBot Edition 3.6.3 - Beta

Posted: Fri Jan 04, 2019 10:12 am
by Brent.I
Want to contribute to Free Software development? Advanced users are needed to test the new alpha release of Cura LulzBot Edition! New features include Bridging detection, Gyroid infill, improved prime tower, and much more.

Advanced users can help by using the new slicing profiles, trying out the new features, and testing your workflow in the new interface. More importantly, we'd love to hear your feedback!

You can get the alpha version from our development site here:

New users are STRONGLY encouraged to use Cura LulzBot Edition 3.2.32 from

Report any bugs or potential improvements here:

Good luck and happy printing!

Re: Cura LulzBot Edition 3.6. - Beta

Posted: Tue Jan 08, 2019 4:02 pm
by Brent.I
3.6.2 has just been pushed to

* Added PolyCast material and profiles for each machine and tool head combination.
* Included point and click support from Lokster -

Plans for 3.6.3 are adding in Support Blocker from @fieldOfView and any other bugs/issues we have reported in the next few days. Please let us know if you run into any problems!

Re: Cura LulzBot Edition 3.6.3 - Beta

Posted: Fri Jan 25, 2019 4:31 pm
by Brent.I
3.6.3 is ready the new features include:

Support Blocker has been included. Point and click to choose where not to automatically generate support. Be sure to turn off "automatically drop models to build plate" in the preference section to use properly

LulzBot Dark Theme is now available. Preferences > Configure Cura > Theme > LulzBot Dark (Restart of program afterwards required) - Any feedback or suggestions on this we would love to hear about! You can log feedback here:

Firmware Set to - We noticed an improper current set for TAZ 5/6, and Mini 1 SL, SE, HS, and HS+ tool heads. This has been corrected

Fixed support infill layer thickness - Issue that was preventing slicing due to improper machine definition fixed.

Please let us know if you have any issues, we will be happy to look into them!

Re: Cura LulzBot Edition 3.6.3 - Beta

Posted: Wed Jan 30, 2019 2:34 pm
by Brent.I
We have completed our smoke test procedure on ticket 3.6.3 smoke test

We haven't found any issues, and would love to get some more feedback! Get the 3.6.3 version of Cura LE here:

Re: Cura LulzBot Edition 3.6.3 - Beta

Posted: Wed May 01, 2019 7:30 pm
by fastrobplus
Browse plugins seems to do nothing. It just opens a blank window.