Best way to print PLA

Filament
1

on a TAZ. Heated? Taped? Lutzjuice?

I’ve tried the later and man was it tough to get the print off the bed :slight_smile:…

Just looking for best practices with PLA on a TAZ if you would be so kind.

Alan

2

I’m fond of printing on bare heated glass at 60C. I place a piece of clean bare glass on the existing heated bed and hold it with binder clips. It releases well when cooled.

3

Some users have encountered flaking or delamination when removing parts when printing on bare glass. We recommend printing with either the stock PET surface, or with the new PEI print surface that some of our more advanced users are using with great success.

Thanks!