Unraveling Spool

Help with printing with specific plastic filaments.
Post Reply
altertalk
Posts: 10
Joined: Sat Aug 27, 2016 8:17 am
Location: Williamsburg, VA

Unraveling Spool

Post by altertalk » Sun Aug 28, 2016 1:06 pm

Hi,

I a using a Lulzbot Mini printing with a Bridge Nylon. Some of my prints last about 4 to 5 hours as I am printing rocket parts for model rocketry. I am finding that as the print proceeds, the filament unravels off the spool, getting wrapped around the spool holder, and in some cases, preventing the filament from advancing into the printer. About every hour or so I have to rewind the spool to prevent this from happening. Has anyone come up with a solution for this?

Since I have a 6" bed, I'm thinking about printing to side discs for the spool, to extend the spool diameter to prevent the unraveling.

kcchen_00
Posts: 1666
Joined: Thu Feb 19, 2015 12:42 am

Re: Unraveling Spool

Post by kcchen_00 » Sun Aug 28, 2016 4:21 pm

Use a roller type spool holder. When the spool sits own the rollers, it prevents the filament from getting out of the spool walls.


When the spool gets to 50%, switch back to your regular spool holder. The spool gets too light and can fall off the rollers.

Post Reply