MatterHackers ABS

I purchased some matter hackers abs filament and have been having a very hard time getting my prints to stay stuck and from time to time my extruder seems as if it’s having issues extruding. After 5 or six attempts and checking e-steps and z height and removed it and put in some lulzbot filament. Zero issues. Print sticks to bed and no extrusion problems.

Has anyone else had issues with matter hackers. Have I just gotten a bad roll or should I avoid buying it in the future?

Well I have only printed about 10 rolls so far of ABS from them, but I have not had much problem with it. But the Lulzbot is less of an issue to print with.