Taz not extruding, Ninjaflex

Hi,

I’ve been printing with Flexystruder and ninjaflex. It has been fine, but recently after a couple of layers, it stops extruding. Any suggestions? Thanks!





Your settings don’t look too far off, save for your layer height of 0.1 mm. At that scale you’ll want to try slowing down your print speed. Give the tested and known-working slicing profiles built into Cura LulzBot Edition a try. Download the latest version at https://LulzBot.com/Cura and use the Fine Quickprint profile for your printer and NinjaFlex and compare results.