Page 1 of 1

Laywood Print Profile

Posted: Fri Aug 10, 2018 1:18 pm
by Mfilipuzzi
Hello,

Does anyone have a pre-defined print profile for Laywood-D3?

Re: Laywood Print Profile

Posted: Tue Aug 14, 2018 8:05 am
by Galadriel
We don't have a predefined profile for Laywood-3D but the profile for our other wood fiber filament Woodfill works really well. Their print temperature ranges are very similar and start at almost the exact same point. When working with Laywood you have a decently wide temperature range and a higher temperature will result in a darker finish to the end product (high end of it's range is 230C) so you may want to play with the temperature a little bit to get the look you want.