Ninjatek ARMADILLO 75D Settings for TAZ 6

I am trying this new material. I need help with the settings. See attached pictures of the result. lots of strings on travel. (this is after clean up ). Overall quality is very poor. ABS result is much better.
I tried to export the profile. But the file is empty. I am using Cura for Lulzbot Edition 3.2.27 on Windows 10.
Travel cooling.png
Build Plate Adhesion and mesh fixes.png
IMG_2900.JPG
IMG_2899.JPG
IMG_2898.JPG
Support.png
Special Modes and Experimenta.png
Shell.png
Infill.png
Material.png
Speed.png
Quality.png

It’s been a while with no answer, hope you figured it out. I found a decent config, thought I’d share it with you just in case.
This is on a Taz6 using the Aerostruder head - I found that’s working much better.