PolyLite PLA Poor adherence shell to infill

Hey folks,

Newbie here, doing a simple 2D-shape extrusion print using my new TAZ 6 and PolyLite PLA.

The prints are consistently NOT building correctly, and the only way I can explain it is that the exterior walls aren’t adhering to each other or the infill.

I end up with thin walls that just… slide off the outside of the model - they’re not fusing to the top or bottom plate, nor the infill. I can simply peel them off the outside like an onion.

What am I doing wrong?

What slicing software are you using? Get the latest version of Cura LulzBot Edition from LulzBot.com/Cura. Once you have the latest version, print your design and if you see this again, send an image to the support team through LulzBot.com/Support.