Help with printing with specific plastic filaments.
2 posts • Page 1 of 1
any advise on printing with cork fill Im using the modular bed Pei side I cannot get the print to stick when it does the nozzle drags anything it touches away from the print eventually causing a clog around the nozzle,, I 'm printing at 210 and trying to keep the nozzle clean but its trying my patience...
What slicing profile are you using? Give the woodFill profiles in Cura LulzBot Edition a go. Reach out to the support team with a picture of your first layer and they'll be able to help make tuning recommendations.