I noticed that there have not been many posts about this lately. They all seem to be 2016. Does anyone have any parameter info for printing with i180 3mm? I have a Taz6 with an enclosure and a dual printhead.
IGUS has a bit of information and a recommended print surface: https://www.igus.com/product/700
If you have a modular bed system you’ll be able to apply that to the bare borosilicate side: https://www.lulzbot.com/store/parts/lulzbot-taz-glass-pei-print-surface https://www.lulzbot.com/store/parts/lulzbot-taz-modular-print-bed-heater
See also: https://forum.lulzbot.com/t/has-anybody-tried-igus-iglide-tribo-filament-yet/3759/1