Hello All not sure if this is the right section of the forum to be posting in but if not please redirect me to the correct spot.
Originally I posted on r/Fixmyprint on Friday (3 November 2017) about an issue with my print quality on my Company’s Taz 5. Recently we upgraded to the lulzbot dual extruder V2 and after upgrading the fans (https://forum.lulzbot.com/t/dual-extruder-v2-heat-block-fan-upgrade/3366/1) had some great success. However, after a weekend I came in and attempted to print a benchy as one last test before printing the complex geometries required for our fast prototyping process. and i began getting an issue where it appeared the corners of the benchy were warping upward but only about 15-20 layers up. You can see my original Reddit post here https://www.reddit.com/r/FixMyPrint/comments/7aivkm/been_trying_to_fix_the_3d_printer_at_the_company/?ref=share&ref_source=link
I took some suggestions and started a new post on fix my print with this benchy (https://imgur.com/a/BNQIe). I also posted my S3D settings there. The thought that the people over there had was that my print was too hot and that my extrusion multiplier was too low. I was suggested to move back to Cura to figure out the issue. When I moved over to cura I printed in a range between 20 and 75mm/s and temps on matter hackers pro pla between 170 and 220 C. Here are my Cura settings https://imgur.com/a/hl52S and here is the link to the most recent reddit post https://www.reddit.com/r/FixMyPrint/comments/7b7xvb/still_struggling_with_company_3d_printer/?ref=share&ref_source=link
At this point both I and my boss are getting frustrated that we cannot print the quality rapid prototypes we need. Any help and suggestions would be greatly appreciated. Feel free to comment on any of my 3 posts that I’ve mentioned as I am checking on them several times a day.