Supports for 28mm Miniatures

Show off your stuff!
Post Reply
Posts: 2
Joined: Mon Jun 18, 2018 1:53 pm

Supports for 28mm Miniatures

Post by Dabme » Mon Jun 18, 2018 2:23 pm

I have a Lulzbot Mini and I use Cura. My goal is to print 28mm tabletop miniatures (mostly for my D&D game)

I'm curious about support settings. I try to avoid supports but when I do use them they are terribly difficult to remove. So what is your strategy for supports for 28mm models?

Your thoughts are appreciated.

User avatar
Posts: 6
Joined: Mon Feb 26, 2018 2:49 am

Re: Supports for 28mm Miniatures

Post by Luis » Tue Jun 19, 2018 7:44 am

I'd try to avoid using the supports if I could :)

User avatar
Aleph Objects | LulzBot
Posts: 31
Joined: Mon Sep 26, 2016 10:46 am

Re: Supports for 28mm Miniatures

Post by NBradshaw » Tue Jun 19, 2018 10:44 am

If you do need to use support for these kinds of prints, then I would recommend changing the Support Z Distance a bit. As a standard it is usually set at a .1mm, but I have found that I can still get really good results with a .15 or even a .2mm setting. I also like to use a 15% support density for just about everything. I have found that these have worked well for most prints, even small, detailed prints.

Post Reply