I have a Lulzbot Mini and I use Cura. My goal is to print 28mm tabletop miniatures (mostly for my D&D game)
I’m curious about support settings. I try to avoid supports but when I do use them they are terribly difficult to remove. So what is your strategy for supports for 28mm models?
If you do need to use support for these kinds of prints, then I would recommend changing the Support Z Distance a bit. As a standard it is usually set at a .1mm, but I have found that I can still get really good results with a .15 or even a .2mm setting. I also like to use a 15% support density for just about everything. I have found that these have worked well for most prints, even small, detailed prints.