Hey Friends,
Long time fan, first time poster. I’m attempting to print a calibration rig, but the prints themselves are just not working out. As you can see in the following images - Taz seems to occasionally be missing the perimeters. I wasn’t sure if this infact was the Taz’s fault, or the .gCode. Any thoughts?
Here is an image of the prints (followed by an image of the model).
I’m using the LulzBot medium no support profile in Slic3r with a fairly high resolution .STL https://s3.amazonaws.com/vigesharing-is-vigecaring/ss/CircleTolerances_0001mm.stl
And here is my .gCode https://s3.amazonaws.com/vigesharing-is-vigecaring/ss/CircleTolerances_0001mm_med-no-support.gcode
Bed was leveled just prior to the print. Using lulzjuice to pre-treat the print bed.
Any thoughts on how to improve these prints? Thanks!