hi all i have been using taz 5 for 1 month now (though a bit depressed that taz 6 is releasing in 2 weeks)
i have recently starting to have issue with my print’s first 2mm base layer tends to shift.
it occurs on any object i tride to print no matter big or small, round or square, tall or short.
I have check the bed level, check the head, tried to apply brim or raft, and as well as lower the printing speed to 30mm/s
I use PLA most of the time, but this happens on all types of material i use.
Please assist me on this issue.
Thank you