Quick Unbox and First Print with the MOARstruder

A forum dedicated to the stock LulzBot TAZ 3D Printer
Post Reply
User avatar
DougZ
Posts: 140
Joined: Wed Jun 01, 2016 8:02 pm
Contact:

Quick Unbox and First Print with the MOARstruder

Post by DougZ » Mon Jan 23, 2017 6:36 am

Got my MOARstruder this weekend and did a very quick & dirty YouTube unboxing and first print with it. Link is below. It is wild to watch a 1.2mm layer being laid down. A few days ago I printed something that took 45 hours but was estimated at 39 hours in Cura. Loaded the same model in Cura while it was configured for the MOARstruder and it estimated just over 10 hours. Not bad!

There aren't many quickprint profiles prepackaged with it interestingly. Lacking is an ABS profile (not sure why) but I'm going to do some experimenting.

This is my first YT so sorry about the camera work & lighting.

https://youtu.be/PDRUSbfPKmE
--
Lulzbot Mini
Lulzbot TAZ6
Follow me on Twitter! @tech3_design

Ryankimharrison
Posts: 10
Joined: Wed Jan 11, 2017 8:41 pm

Re: Quick Unbox and First Print with the MOARstruder

Post by Ryankimharrison » Sat Feb 04, 2017 9:59 am

Cool! I subscribed to u

Post Reply