Quick Unbox and First Print with the MOARstruder

Got my MOARstruder this weekend and did a very quick & dirty YouTube unboxing and first print with it. Link is below. It is wild to watch a 1.2mm layer being laid down. A few days ago I printed something that took 45 hours but was estimated at 39 hours in Cura. Loaded the same model in Cura while it was configured for the MOARstruder and it estimated just over 10 hours. Not bad!

There aren’t many quickprint profiles prepackaged with it interestingly. Lacking is an ABS profile (not sure why) but I’m going to do some experimenting.

This is my first YT so sorry about the camera work & lighting.

https://youtu.be/PDRUSbfPKmE

Cool! I subscribed to u