Taz 6 Extruder Harness Snagging Prints Leading to Failue

So I have discovered that the harness hose that is zip tied to the frame binds against very large prints in the build volume when the printer gets close to full height in the print leading to failure. I noticed a huge gash in the hose where it caught my last print before it ripped a 48 hour print off the bed. Does anyone have a solution for holding the hose up above the build volume? I tried moving it around but it seems that the range of motion might be affected if it gets moved from where it is too much…

I’ll update this with a photo when the next print (in progress) gets to the point of snagging…

There isn’t really a good solution to that. If the cable is too short, your only option is to make it longer, and adaptors don’t work well in that location. If you are handy at crimping and wire stripping the parts should be in one of the ods files in here: http://download.lulzbot.com/TAZ/6.01/production_docs/ (excel will open them)
The is a Y axis cable chain modification that will fit the Taz 6 http://www.thingiverse.com/thing:1145951 , but i’m not aware of a cable chain mod that will fit the stock taz X carriage. Technically you can fit my openbuilds Taz 6 X axis and make the Taz 5 cable chain setup for it fit http://www.thingiverse.com/thing:1277441, but either way you would still need to extend the wire, and I don’t know that the cable exit points are really going to line up on a 6 box since I don’t have one to test with.