Printing ABS at 110C for the first layer.
I’d like to be able to preheat the bed so that I can let everything stabilize before probing, but I’m noticing the temperature drops about 20C during the auto-leveling sequence. So besides being at random temps when probing, it also takes about 10 minutes to get back up to temp. Some times I have to restart the print because of a funky first layer and when it’s all said and done it can be up to 30-40 minutes just to get a good print started.
Is there any control for the bed probing temperature in the firmware or maybe a G-code command to control this?