Hey folks, I have been trying to print with PETG lately, and for some reason, my prints are leaning on the X axis. See pic.
I’m using eSun grey with a bed @ 65 and a nozzle @ 240.
The precision of the prints is good. Little stringing and otherwise clean.
I don’t have these issues with PLA or ABS.
I checked my pully and gear, and the belt. All seems good and tight.
OK. I take it back…Seems to be happening to PLA too.
I should also note, I recently replaced the MoBo (same model) and loaded up the firmware from the Lulzbot site. (Taz5)
Could it be a calibration issue?
