Taz 6 Probe Failed Clean Nozzle errors

So I was able to initially get some prints but now the machine constantly fails to print on PROBE FAILED CLEAN NOZ errors. I cleaned all the parts of the nozzle, contact points, and print bed and even heated the end of the nozzle up to 200C to clear out old filament. Any ideas how to get past this issue? I am very frustrated at how unreliable this printer is for the amount that I spent on it!

After homing the printer measure the right and left rod distance and make sure your X axis is level in relation to the bed surface. It may have become uneven, and if so the auto leveling routine can not adjust if too far out.

Thanks I fixed it by adjusting the right Z axis motor per support.