Page 1 of 1

My TAZ 5 stops and no longer wants to print

Posted: Thu Jun 15, 2017 9:08 am
by Ernesto Renteria
Everything was fine but today the printer no longer wants to print, when I want to make a piece the printer starts well, but suddenly stops and no longer continues. Already try to pause it and give it continue, does the calibration movement but does not continue with the work.

Cancel the works, the command to print again but the same thing happens again.

Re: My TAZ 5 stops and no longer wants to print

Posted: Thu Jun 15, 2017 1:54 pm
by jim2386
Ernesto Renteria wrote:Everything was fine but today the printer no longer wants to print, when I want to make a piece the printer starts well, but suddenly stops and no longer continues. Already try to pause it and give it continue, does the calibration movement but does not continue with the work.

Cancel the works, the command to print again but the same thing happens again.
What does your serial terminal say when it stops?

Does your temperature of your nozzle and bed go up or stay at room temp?

Re: My TAZ 5 stops and no longer wants to print

Posted: Thu Jun 15, 2017 4:34 pm
by Ernesto Renteria
Hi Jim

The terminal remains as if the machine is printing.

The room is cold but the bed and nozzle temperature stays warm.

Re: My TAZ 5 stops and no longer wants to print

Posted: Thu Jun 15, 2017 7:39 pm
by Rookie
Was you STL file clean? Did you run it through a mesh mixer and correct errors? That got me once.

viewtopic.php?f=36&t=2365&hilit=stops

Re: My TAZ 5 stops and no longer wants to print

Posted: Fri Jun 16, 2017 11:53 am
by Ernesto Renteria
After two attempts and to restart the computer, the printer finished the piece.

It is a simple but large piece, I did not verify the STL file, I do not know how to do it.