Hi All,
Just started a print after a little break ~2 months of using the machine and after a small relocation of the printer and I’m getting an error on the display of endstop hit: x and causing a layer shift that ruined the print. Luckily it didn’t waste much filament but it’s still annoying. Can anyone help me troubleshoot? Is it a loose wire perhaps? Problem with the Gcode? I had a little tangle that caused the printer to bind up a while back and caused the z axis to grind but I levelled that out and doesn’t seem to be an issue anymore but never had an issue with the x. For the record is x side to side or front to back? It seems to be a side to side shift but also slightly front to back.
The print isn’t using the full build plate - I’d say 10x10 inches or so.