Nozzle replacement for Taz 2

I recently picked up a Taz 2 which came with a 0.5mm nozzle. I would like to go smaller (0.2mm) to do fine prints but as I’m very new to all of this, I was curious where I could buy one and if I needed to get any specific sort of nozzle? The store here doesn’t seem to sell nozzles for the Taz 2 that I can find.

Thank you!

The taz 2 used the old buddaschnozzle 2.0c nozzle. Finding nozzles for them are nearly impossible anymore. Itworks3d.com may possibly have some.

That being said, swapping a nozzle on those old style hotends is more likely than not going to strip the threads. You may need to upgrade if that occurs.

Upgrade… the entire hotend?

Thank you for the response, too!