guys i have a Taz6 for several months and ATM using Hatchet 3.00 PLA at 205C
My issue is every time it lays the initial layer it curls up, making it useless and i abort. Now i have tried 2 different types of PLA and it does the same.
could i be having a tool issue??? i have a new extra one that i can try it with, or was the design of the item to be printed not right??
any help appreciated
This sounds like it could be a bed adhesion issue but it is tough to say based on the description. Could you post a couple photos of what your failed prints are coming out like when they are still on the print bed?
Well heck , i fixed the issue, not enough glue…put a thick layer of elemer’s on it now the print went without a hitch
Thanks for the response
Sovrin