Aerostruder Z-offset

A forum dedicated to the stock LulzBot TAZ 3D Printer
Post Reply
InfiniteGinger
Posts: 31
Joined: Sun Feb 19, 2017 8:01 pm

Aerostruder Z-offset

Post by InfiniteGinger » Tue Jun 26, 2018 9:06 am

Forgiveness if this has already been addressed, a quick search of the forums didn't appear to yield the answer.

For those of you with the L.B. Aerostruder, did you have to significantly alter your Z-height offset? Mine was printing way to close to the bed at -1.35, like WAY to close. The bottoms on my prints were smooth and lettering from Benchy, totally invisible. Dimensional accuracy also seemed off by 1-2%

I had to change the offset all the way up to -.8 any closer to the bed and the first layer didn't look right.

Just curious if anyone else experienced this on their Taz 6 with Aero.

Ehoff
Aleph Objects | LulzBot
Posts: 60
Joined: Fri Sep 08, 2017 1:34 pm

Re: Aerostruder Z-offset

Post by Ehoff » Thu Aug 02, 2018 10:17 am

I didn't have to adjust my z-offset when upgrading to the aerostruder, however if you are having problems with the first layer, here is a picture showing what a good first layer line should look like.
1st_layer_adhesion.jpg
1st_layer_adhesion.jpg (13.84 KiB) Viewed 202 times

Post Reply