First few layers

A forum dedicated to the stock LulzBot TAZ 3D Printer
aumandg
Posts: 13
Joined: Wed Mar 13, 2019 5:47 pm

Re: First few layers

Post by aumandg » Fri Mar 22, 2019 5:33 pm

appreciate it, ty

ritmopat
Posts: 100
Joined: Wed Feb 13, 2019 9:22 am

Re: First few layers

Post by ritmopat » Sat Mar 23, 2019 8:41 am

the version I'm using is 21.04 came with the printer..like I mentioned some are having issues.... are you printing with the chip card or from the computer..I think I had my issue when using the chip card..I'll be trying it out sometime in a few days to see if the newer cura is working for me...

aumandg
Posts: 13
Joined: Wed Mar 13, 2019 5:47 pm

Re: First few layers

Post by aumandg » Sat Mar 23, 2019 12:36 pm

I figured out the issue, it is with my bed, there is a crack in it so it is not flat, there is a dip in the bed so the filament will not contact the bed for the first few layers to adhere correctly.

I did find this link to old versions of the software, http://download.lulzbot.com/Software/cu ... t/windows/

Thank you for your help.

ritmopat
Posts: 100
Joined: Wed Feb 13, 2019 9:22 am

Re: First few layers

Post by ritmopat » Sat Mar 23, 2019 1:44 pm

glad you got it!

NebNorse
Posts: 6
Joined: Fri Apr 12, 2019 6:28 pm

Re: First few layers

Post by NebNorse » Fri Apr 12, 2019 6:39 pm

New Taz owner here. Having a similar issue but just with the second layer. The first and third print fine. The second is wavy and looks almost like it is not putting enough filament down. But then the Third and rest of the layers are nice and flat and well bonded. Tried with nGen, PLA, and even Bronzfill... all the same.

I am using Cura 2.6.52

What setting/settings could I be missing?

Post Reply