Upgrading the firmware on the LulzBot Prusa

A forum dedicated to the stock LulzBot Prusa 3D Printer
classicaviator
Posts: 5
Joined: Mon Sep 16, 2013 5:18 pm

Re: Upgrading the firmware on the LulzBot Prusa

Post by classicaviator » Wed Sep 25, 2013 5:53 pm

Thanks guys, this helped! I lowered the temp to 170 and sped up the speeds quite a bit. I've also lowered the acceleration rates in firmware and it now prints like buttah, literally!

jebba
Site Admin
Posts: 689
Joined: Mon Mar 25, 2013 4:11 pm

Re: Upgrading the firmware on the LulzBot Prusa

Post by jebba » Thu Sep 26, 2013 6:53 pm

classicaviator wrote:Thanks guys, this helped! I lowered the temp to 170 and sped up the speeds quite a bit. I've also lowered the acceleration rates in firmware and it now prints like buttah, literally!
Good to hear.

Happy printing!

Post Reply