While this is my first post I didn’t want it to be a problem question but seems I can’t avoid it. After receiving my KitTAZ I was able to assemble it with almost no issue. While there where some vitamins missing and a replacement part had to be shipped out due to missing a piece I was able to complete the build in about 10 hours over the course of 2 weeks.
The issue I have now it that my Budaschnozzle melded after both Printer Interface and CURA reported the hot end being at 60 but the temperature was obviously much higher. As you can see in the photos the hotend is now totally warped.
https://drive.google.com/file/d/0B6qF-1j5N_-yZ1RSZ3BiYndnZkE/view?usp=sharing
https://drive.google.com/file/d/0B6qF-1j5N_-ycUExRkpFbk9iVW8/view?usp=sharing
https://drive.google.com/file/d/0B6qF-1j5N_-ySExDR1Zvc09WbEk/view?usp=sharing
The following video below shows Printer Interface showing the temp at 60 but as you can see with smoke puffing out of the nozzle and melting a small piece of ABS filament there is a major temperature difference.
My question is does any one know of a way to fix this issue. I understand that the hotend is probably shot and will need a replacement but the issue remains of the current correct temperature not going past 60 within the software. I Already checked the simple things like the connectors being attached and even double checked the connections to the Rambo Board as pictured.
https://drive.google.com/file/d/0B6qF-1j5N_-yM1dtcnBySUU0WkE/view?usp=sharing
https://drive.google.com/file/d/0B6qF-1j5N_-yOG5Vd3N4aTZhZDA/view?usp=sharing
I have already sent off the pictures to support but didn’t know if anyone on here might have answer or solution to my current problem or is anyone else has experienced this. Kinda of disappointed as it’s already been about 2 weeks and still haven’t printed anything as waiting on parts and now this as left me in limbo