Page 1 of 11

RazzMaTAZZ - my KITTAZ Build

Posted: Fri Feb 27, 2015 9:30 am
by mhackney
I was surprised no one grabbed RazzMaTAZZ to name their printer! I'm going to document the build and plans to evolve this printer into a high resolution, double wide (24" x 12" X-Y), single-nozzle dual extrusion (Cyclops) system. But, I'll start with the basics...

First the perfunctory UNBOXING:
Image

Image

Image

Image

Image

Image

Everything nicely packed and labeled.

Some quick observations: I was impressed with the quality of the printed parts and especially the pressed-in brass threaded inserts. Nice touch will result in easier assembly and a stronger, better overall build.

Extruder Assembly

Posted: Fri Feb 27, 2015 9:31 am
by mhackney
First up, the extruder.

Image

I never get tired of extruder builds. The Wade's is a workhorse. This one was nicely printed and went together easily. I really like the thumbscrews for the spring tensioner adjustment, nice touch.

Image

Print head complete

Posted: Fri Feb 27, 2015 11:11 am
by mhackney
Image

Straight-forward assembly. I'm not used to such massive print heads - delta's remote the extruder and the print head is small and light.

Y Plate Assembly

Posted: Fri Feb 27, 2015 12:00 pm
by mhackney
Firstly, I noticed that the bottoms of the linear guide holders were not flat so I used a fine file to clean them up:

Image

Here's the completed assembly:

Image

Re: RazzMaTAZZ - my KITTAZ Build

Posted: Fri Feb 27, 2015 12:14 pm
by JonathanB
Yep, I ran those bearing holders on a sandng disc, did the trick..all the little necessary finishing stuff. No big deal right ;)

Y Axis Assembly

Posted: Fri Feb 27, 2015 1:27 pm
by mhackney
I skipped the bed assembly and went on to the Y Axis Assembly.

Image

It all went together smoothly. The only note - the M2 crews (Bag 3) for the limit switches are called as M2 x 12mm - the bag actually contains 10mm long screws and they fit perfectly. So far, the instructions and parts have been spot on.

Control Box Assembly

Posted: Fri Feb 27, 2015 1:47 pm
by mhackney
Not worth photographing - attached the fan to the control box lid. I really like the control box, clean and functional.

Easiest wiring job on any machine I've ever built! All the harnesses are cut to length, terminals pre-crimped, ready to plug and play.

Image

X Carriage Assembly

Posted: Fri Feb 27, 2015 2:53 pm
by mhackney
Humming right along with the build.

Image

X End Idler Assembly

Posted: Fri Feb 27, 2015 3:04 pm
by mhackney
Image

X Motor Assembly

Posted: Fri Feb 27, 2015 3:41 pm
by mhackney
Image

And now on to the fun stuff - frame assembly and finishing up!