Problem with graphic display.

A forum dedicated to those intrepid few, that have built their own TAZ 3D printers using our KITTAZ.
Post Reply
saramos
Posts: 195
Joined: Fri Sep 19, 2014 1:05 am

Problem with graphic display.

Post by saramos » Tue Mar 24, 2015 1:23 am

Well, I've completed the construction of my Kittaz, and have flashed the controller. I also added the LCD display. However, when I power up, the display lights up, but nothing is displayed. Is there another flash procedure that needs to be done, or perhaps I have a misconnected cable, or may there be a fault with my display?

Oh, also, my kit was missing 4 5Mx14 screws and 2 5Mx14 thumbscrews. I was able to get replacements for the capscrews locally, but would it be possible to get the two thumbscrews?

Thanks in advance,

Scott

saramos
Posts: 195
Joined: Fri Sep 19, 2014 1:05 am

Re: Problem with graphic display.

Post by saramos » Tue Mar 24, 2015 1:39 am

Did some checking and found that I had incorrectly connected the cables. I corrected the connections, and all is well with the graphic controller/display.


Scott

User avatar
do-it-for-science-
Posts: 74
Joined: Sat Jan 17, 2015 8:02 pm
Location: Wilsonville, Oregon

Re: Problem with graphic display.

Post by do-it-for-science- » Thu Apr 16, 2015 2:47 pm

what display did you use? where did you get it?
open source, open heart,

Jeff Hunt,
Renewable Energy Engineering student OIT

Post Reply