Poor print quality in same area - always

A forum dedicated to the stock LulzBot Mini 3D Printer
Post Reply
mhristau
Posts: 44
Joined: Sun Jun 24, 2018 3:18 pm
Contact:

Poor print quality in same area - always

Post by mhristau » Tue Dec 11, 2018 9:29 pm

Most of my printing is of small parts... positioned in the center of the build plate.
However, when I print a group of refined parts (50-100) I am reminded that I loose quality in the back right area of the plate. My mini 2 has had this problem from the start. Something in the leveling? I have removed the plate, cleaned and reassembled with same torque at each of the four corners... Suggestions??
IMG_0965.jpg

kcchen_00
Posts: 1695
Joined: Thu Feb 19, 2015 12:42 am

Re: Poor print quality in same area - always

Post by kcchen_00 » Wed Dec 12, 2018 4:26 pm

Check the belts. Looks like its an anomaly with the X & Y-axis... Clean the rods, check the belt and attachment points to the bed and x-carriage. Try printing a calibration cube in the affected area and take measurements / post pictures.

Post Reply