nozzle never touching washers

my print nozzle never touches the washer to start the bed leveling off the noozle position is slightly behind the rear left washer. it wiped fine but never touched and i get wipe nozzle failed and tells me to cleans the nozzle which is brand new and it has been cleaned over and over as i hadnt got it past this point yet.

It sounds like your x-axis may be a bit unlevel and unable to reach that corner.
Follow this guide to get that fixed: https://ohai.lulzbot.com/project/leveling-x-axis/maintenance-repairs/

It’s for a TAZ6 but the process is the same.

Is this a mini 1 or 2?