my print nozzle never touches the washer to start the bed leveling off the noozle position is slightly behind the rear left washer. it wiped fine but never touched and i get wipe nozzle failed and tells me to cleans the nozzle which is brand new and it has been cleaned over and over as i hadnt got it past this point yet.
It sounds like your x-axis may be a bit unlevel and unable to reach that corner.
Follow this guide to get that fixed: https://ohai.lulzbot.com/project/leveling-x-axis/maintenance-repairs/
It’s for a TAZ6 but the process is the same.
Is this a mini 1 or 2?