First let me say im really happy with my lulzbot mini , ran into a problem last week when the nozzle would dig into the wiper mount and jam up. other times it would hit the side wall of the mount and then stop.
Quick solution was to remove the wiper mount all together and manually wipe the nozzle when its stationary.
I’m using a quick print option any clues on what is going on ?
There is quite a bit of “wiggle” room with the mount, so you could possibly just loosen the two screws and situate the wiper pad to have it not hit the mount?
when i put the wiper mount back on ,but flipped it, i tightened the screws and that seemed to work , may be it was loose before and the head clipped the side of the mount when it was raising it and got stuck.