Mini graphical LCD Y axis offset

After adding the mini graphical LCD, the entire operation from wipe to print seems to be offset in the y-axis by ~4mm.

I am using Simplify3D to generate gcode. What setting should be adjusted to fix this?

Grab the latest start & end gcode from the latest version of Cura LulzBot Edition. The coordinate system on LulzBot Mini 3D printers shifted slightly to allow for unified firmware across the LulzBot Mini line.

Reach out to our support team if the latest start & end gcode doesn’t solve this for you. You’ll want to also run a test print using the latest Cura LE to minimize your variables.

Thanks! That fixed it.