Hey folks. I recently upgrade OSX, which required me to upgrade CURA, which for some reason forced me to re-flash my mini, and I therefore lost my settings…
On top of that the new CURA doesn’t seem to want to import my saved print profiles. So essentially I lost everything that used to allow my printer to print accurately!
I went through and re-did my esteps like before and adjusted some of the settings like before as well and it’s printing horribly off (compared to before). For example I’ve created a test cube of my own that’s 20mmX x 10mmY x 15mmZ (helps me remember the axis used having different sizes). I was getting results like 20.24x 10.13y and 14.87z! Makes printing things that are supposed to fit together pretty hard.
I knew the risks of adjusting XYZ steps but I gave that a try anyways. I can then make it print perfectly on small objects but as expected it made a 5" square object as far as 1/16" off (too small). So yeah, I reversed those changes hahaha.
Is there something about the new CURA that could be making my new prints so much more off then they used to be under similar circumstances? Is there something I’m missing?
Best,
Chris