The PEI layer on my bed is all bubbled up after some pretty hard us. I can’t complain as it has done a lot of prints, but now I’m at the point where it does need to be replaced.
If anyone has done this and can share advice I would be very grateful
Cheers
Les
We have a guide located here that goes over replacing the PEI sheet. https://ohai.lulzbot.com/project/mini-replacing-pei/maintenance-repairs/
The steps are the same for the Taz or the Mini. We also have a video here: https://www.youtube.com/watch?v=PH_L0xvZBrs
Thanks - looks like I need to learn how to fit heaters too, see my other new post!