PEI layer replacement - has anyone done it?

A forum dedicated to the stock LulzBot Mini 3D Printer
Post Reply
lesthegringo
Posts: 76
Joined: Mon Dec 26, 2016 9:41 pm

PEI layer replacement - has anyone done it?

Post by lesthegringo » Sat Jun 16, 2018 11:11 pm

The PEI layer on my bed is all bubbled up after some pretty hard us. I can't complain as it has done a lot of prints, but now I'm at the point where it does need to be replaced.

If anyone has done this and can share advice I would be very grateful

Cheers

Les

Ehoff
Aleph Objects | LulzBot
Posts: 60
Joined: Fri Sep 08, 2017 1:34 pm

Re: PEI layer replacement - has anyone done it?

Post by Ehoff » Sun Jun 17, 2018 9:44 am

We have a guide located here that goes over replacing the PEI sheet. https://ohai.lulzbot.com/project/mini-r ... e-repairs/

The steps are the same for the Taz or the Mini. We also have a video here: https://www.youtube.com/watch?v=PH_L0xvZBrs

lesthegringo
Posts: 76
Joined: Mon Dec 26, 2016 9:41 pm

Re: PEI layer replacement - has anyone done it?

Post by lesthegringo » Mon Jun 18, 2018 1:39 am

Thanks - looks like I need to learn how to fit heaters too, see my other new post!

Cheers

Les

Post Reply